- Joined
- Sep 3, 2012
- Messages
- 23
- Motherboard
- ASUS Strix Z270E
- CPU
- i7 7700K
- Graphics
- Sapphire R7 260x
- Mobile Phone
Ok, I just made a new USB boot with Unibeast 7.1.1 and now I can see the installation icon, then, double click and runs smooth until the "prohibitted sign" and.. thats it .
This is my first Hackintosh build so I'm reading a lot but haven't found anything directly with 10.12.6...
My build consists of:
CPU: i5 6600k
RAM: Corsair Vengeance 16gb 3000mhz
MOB: gigabyte z270xp-sli
NO graphic card -> Really don't know what intel graphics does it have suppose its 6xx
Hard drive: Samsung SSD 850 M2 with 500gb
Wifi/BT: installed a Fenvo FV9801 (got it from a friend, don't know if its really supported) - I think its my first suspect that causes failure to proceed
aaand... trying to install Siera 10.12.6 (also downloaded Multibeast 9.2)
Thanks for all the help you can provide!
prohibited sign means your clover config isnt matching with your hardware OR your UEFI setting isnt correct.
Try this-
- make usb using Unibeast- use UEFI Boot Mode in unibeast. Dont select anything in Graphics Configuration and dont modify EFI partition or clover setting of USB
- Check uefi settings, make it similar to following
1. To access BIOS/UEFI Setup, press and hold Delete on a USB Keyboard while the system is booting up
2. Load Optimized Defaults
3. If your CPU supports VT-d, disable it
4. If your system has CFG-Lock, disable it
5. If your system has Secure Boot Mode, disable it
6. Set OS Type to Other OS
7. If your system has IO SerialPort, disable it
8. Set XHCI Handoff to Enabled
9. If you have a 6 series or x58 system with AWARD BIOS, disable USB 3.0
10. Save and exit.
2. Load Optimized Defaults
3. If your CPU supports VT-d, disable it
4. If your system has CFG-Lock, disable it
5. If your system has Secure Boot Mode, disable it
6. Set OS Type to Other OS
7. If your system has IO SerialPort, disable it
8. Set XHCI Handoff to Enabled
9. If you have a 6 series or x58 system with AWARD BIOS, disable USB 3.0
10. Save and exit.
Last edited: