- Joined
- Oct 7, 2011
- Messages
- 144
- Motherboard
- ASUS ProArt Z490 Creator 10G
- CPU
- i7-10700K
- Graphics
- Integrated Graphics Processor
Yup... that's exactly what I did. Not sure what else could be wrong? See attached config/results. Any ideas? I went through the whole guide and still get the darn BoardSerialNumber is not what I have entered.
Yea, I've done all that too and it's not changing to what I enter and still has the '='. I'll try the new config.plist tonight. I started with chimera and swapped to clover. That's how I did it with my other hackintosh. I didn't try a clean clover install on this laptop because it's a laptop I couldn't find any info on so I went the easiest route I could since I already had the chimera usb installer. I might try a clover install since I know I can at least get it functioning now and have a config.plist file that I can work with.
Also, should you enter a number in the Board Serial Number in SMbios on Cliver Configurator? I've read other articles that say to enter a number there rather than in RT Variables?