- Joined
- Jan 3, 2013
- Messages
- 29
- Motherboard
- Asus X99-Deluxe-II
- CPU
- i7-6950X
- Graphics
- 1080
You should follow the originating post of this thread, i.e. my new 10.13 High Sierra Desktop Guide, for the High Sierra PB3/DP4 flash drive generation. The easiest way might be just to perform steps 1) to 6) of my #post 132 !!
Further note that the EFI folder in EFI-10.13-TM-040817a.zip will not boot an old 10.12 macOS Sierra USB Flash Drive installer!!
The previous BIOS settings from my 10.12 Sierra Desktop Guide should be fine, however compare them with those summarized in the originating post of this thread, i.e. my new 10.13 High Sierra Desktop Guide!
Now please summarize for all others here in this thread your actual BIOS settings for the ASUS X99 Deluxe II! Just comment which of my BIOS settings mentioned in my 10.13 High Sierra Desktop Guide you did apply and which of my BIOS settings you could not apply. I also ask once more all other already successful users to subsequently provide their feedback and comments in case of yet missing important BIOS settings for the ASUS X99 Deluxe II.
Cheers,
KGP
Here are the Bios settings for my 10.13 PB3/DP4 attempts:
Started with Load Optimized defaults.
\AI Tweaker:
Ai Overclock Tuner - Set to Auto, no option for disabled
CPU Core Ratio - Auto
\Advanced\CPU Configuration\CPU Power Management Configuration:
Enhanced Intel SpeedStep Technology - Enabled
CPU C-State - Enabled
Enhanced C1 State - Enabled
CPU C3 Report - Enabled
CPU C6 Report - Enabled
Package C-State Limit - C6(non Rentention) State
\Advanced\USB Configuration:
Intel xHCI Mode - Smart Auto
EHCI Legacy Support - Enabled
xHCI Hand-off - Enabled
EHCI Hand-off - Enabled
\Advanced\Onboard Devices Configuration:
SPDIF Out Type - HDMI
PCIEX16_2 Bandwidth - Auto
RGB LED lighting - On
RGB LED lighting effects - Static
RGB LED Lighting color - RED
Serial Port - N/A no serial port on this board
\Boot:
Fast Boot - Disabled
Boot Logo Display - Full Screen
Boot up NumLock State - Disabled
Above 4G Decoding - Enabled
Setup Mode - Advanced Mode
\Boot\CSM (Compatibility Support Module):
Launch CSM - SDisabled
\Boot\Secure Boot:
OS Type - Other OS
All the rest of the settings are at unity with Optimized Defaults.