- Joined
- Jul 17, 2015
- Messages
- 185
- Motherboard
- HP Pavilion 15 dk0xxx
- CPU
- i7-9750H
- Graphics
- UHD 630 + GTX 1650, 1920x1080
- Mac
- Mobile Phone
Okay. Thank YouRemove GenericUSBXHCI.kext, not for your hardware.
Use the non-spoof config.plist. Spoofing Kaby Lake as Skylake is not necessary in 10.12.6+.
Make sure you're using the latest Clover release from SourceForge.
Are you using the latest Clover release?Okay. Thank You
So I did follow the guideline by using the non-spoof config.plist and removed GenericUSBXHCI.kext. Now I am able to reach the installer but during installation it says 2 minutes remaining and suddenly shutdown call gets initiated and the system reboots.
I have tried capturing the output. It misses some lines at the end that were there for a fraction of second only.
Are you using the latest Clover release?
As it shuts down, I'm not sure it's actually an error (I could be wrong). Isn't there any other boot option besides the USB installer after it happens?
I'm sorry but I can't find the stated kext. Can you please point me to the location? I have attached the EFI partition below.Disable smcbatterymanager.kext from start up. Replace with acpibatterymanager.kext
My hackintosh when it reached 2 mins remaining it reboots. If then I try to boot the drive I get the error "The Installer Resources not found". If I boot USB installation starts again and then same error appears. Also every time I am getting the output kextd stall AppleACPICPUNevermind. As far as I can see from your clover folder you haven't any of these kexts , so the problem must be other.
update your clover version to the latest via sourceforgeMy hackintosh when it reached 2 mins remaining it reboots. If then I try to boot the drive I get the error "The Installer Resources not found". If I boot USB installation starts again and then same error appears. Also every time I am getting the output kextd stall AppleACPICPU
Yes there is an option to boot from the drive. But a new error pops up there. Kindly have a look.
[/QUO
hey buddy change year in bios take an previous year 2018Yes there is an option to boot from the drive. But a new error pops up there. Kindly have a look.