apple logo

Hello, at this week I finished my first hackintosh installation. There were a few issues but fortunately I could solve them until this problem. I created a bootable USB with High sierra and installed it on a dedicated HDD (HFS). After the installation, I booted from USB and used Multibeast...

I ve made all the requested steps, but when I reach the apple logo (after selecting the external boot) it freezes a few seconds and when the "progress bar" appears the pc restarts. I have a Gigabyte G41MT-S2 with Ati Radeon 500 (not sure the graphic card number). I tried with safe mode, verbose...

HELP ME Please ! Running Sierra and it worked for months and now it doesn't. Stuck on apple logo and partial load bar. See attached pictures of error. I have removed all usb devices and tried some other solutions from other threads but no luck. Gtx 1060 I7 7700k Z270x ud5 Thanks in advance!

First time poster/long time reader. I really appreciate this community and admire your knowledge and willingness to help each other out. I've read many other threads that seemed to relate to my issue but was never able to fully resolve anything. So here I am. I had a successful first build that...

So today i downloaded High Sierra setup on my working Sierra hackintosh removed any additional kexts and installed the latest version of Clover bootloader I ran the setup and after restart when i selected Install OS X from disk in the clover the apple logo and the loading bar appears and i...

Please help guys! This is my first hackintosh. To create the usb was hard but it worked...But now when im going to install sierra, it shows the apple logo and then its just restarting. When i try to install in safe mode, its just keep shows osxaptiofixdrv-64.efi error for a few seconds before...

Hi, i started installation from my working sierra, so i selected boot mac os install from Macintosh HD, but when i boot it, it got stucked on apple boot logo without loading bar, and if i run in verbose mode i got this. help?!?! EDIT: i have not installed nvidia driver, for mac i use my intel...

Hey Guys, I tried to install MacOS High Sierra following the installation guide on here. First time round worked well, however due to an issue I decided to start over and fresh install again. The installation is complete and I'm trying to boot from SSD but now I get stuck at the apple logo...

installing sierra on a z270 gigabyte ultra gaming motherboard using an i5 7600k and multiple configs have been tried. Install has halted at halfway and will not move past it. Verbose mode leaves little for me to understand, can anyone help? Cpu: i5 7600k running at 4.2ghz Gpu: N/A Ram...

Hi, When I try to boot to my external flash drive with the Sierra installer on it everything seems fine but then when the loading bar underneath the apple shoes up it does not move! I have tried entering "-v" in the boot args but when I push enter the whole clover boot menu just freezes! Any...

This is my first hackintosh build and I ran into a problem. (Booting from the USB Drive because I have not been able to reach past boot) After the apple logo has loaded(progress bar complete) , I get no video signal. I have tried running in verbose and I get no signal after. On the other hand...

Hi, when I boot my hackintosh, everything works fine but it does not progress from the apple logo. It just stays there, I have even left it overnight. Running the os in verbose mode gives me a series of asterisks and a dash: ****************_ Please help me fix this problem. I am running a dell...

So for the most part I have got OSX Sierra working on my hackintosh with only a few minor bugs. The most annoying of those bugs is when booting into sierra it won't always boot. It'll hang on the apple logo screen for a second and either the loading bar will appear and it'll boot. or the apple...

I am trying to turn my PC into a Hackintosh, I have; Gigabyte GA-B250M-DS3H GTX 960 (MSI Twin Frozr) 8GB of Crucial DDR4 RAM As well as the aforementioned Pentium G4560 I have created the boot drive, and it boots to the drive correctly etc. When I am trying to boot into the installer, I get...

Jumped my system from a 980ti to a 1080ti and now when I boot up the system to the hackintosh SSD, it loads the apple logo extremely slow then when it is about 3/4 way though, the system completely shuts down. Has this happened to anyone? I find it weird because it was just working perfectly...

I went into clover and selected my Mac OS Sierra USB to install Sierra and then it brought me to a loading apple logo and the loading did not move at all. Here are some photos. I use Intel Core i7-6700k GTX 1060 with ASUS maxiumus VIII Hero. Please help! IMG_2106 by GuillermoFletes posted May...

First time seeking help here, Was working fine earlier, booted up with clover to find it got stuck at apple logo. Verbose mode shows the stuck at sound assertion. The build consists of asus z87-pro with i7-4770k, gtx 970 and 8+8gb vengeance ram.

Hi, I'm new in this forum so i don't know if I have choose the right category if it's not, sorry and sorry for my bad english too. So I've create a UniBeast pen-drive with Sierra OS X then I've followed the guide and when in the UniBeast boot menù I choose External then i press enter first it's...

Hi, in need of some help. I'm trying to install macOS Sierra on an internal SSD on my custom built PC but the installation gets stuck on the Apple Logo and the loading bar. I've followed the instructions listed here...

Hi, guys I've installed macOS Sierra in this computer. But It's stuck at apple logo this time I want to reinstall. I'm using Unibeast 7.0.1 and macOS Sierra 10.12.3 to create the boot USB stick with default setting. Here my specs: Motherboard: H87N-WiFi CPU: Intel i5 4570 RAM: 2x DDR3 8GB...