Glad to hear it! Was it any particular setting in config.plist? Any lesson you'd like to share?
I don't know what it was exactly, but I guess my old EFI was polluted somehow. So, I decided to start building the EFI from scratch, using your tutorials and pre-made files.
Steps to go from an old pc to this new pc, using the same SSD which was already installed with Catalina 10.15.4 using Clover R5108.
1. Just to be sure the MSR 0xE2 was correctly configured, I took these steps (it was correct already but I thought it didn’t hurt anyhow):
https://www.tonymacx86.com/threads/...olt-3-i7-9700k-amd-rx-580.267551/post-2092710
2. Shutdown the PC and I took my SSD out and hooked it up using a SSD case, so that I could connect it via USB to my MacBook to configure from there.
3. Mount the EFI using Clover Configurator and deleted the EFI entirely from the SSD (so I didn’t erase the SSD, but only the EFI folder after mounting it).
4. Then from
https://www.tonymacx86.com/threads/...olt-3-i7-9700k-amd-rx-580.267551/post-2092711 I started at step 1, but instead of preparing a USB stick (bullet 1,2 and 3 which I didn’t needed…), I configured the SSD from my MacBook starting from bullet 4 until the end of step 1.
5. Unmounted EFI using Clover Configurator and placed my SSD in the new PC and booted.
6. After that I had a functional system and only needed to perform a log-out log-in in iCloud, and needed to map my USB ports (from the new PC itself), so I used an existing custom SSDT from your begin post under “
Custom USB SSDTs” since I have the R6 case.
https://www.tonymacx86.com/threads/...390-thunderbolt-3-i7-9700k-amd-rx-580.267551/
I also ordered a 9-pin split cable, so that I can also install my Fenvi T919.