[SUCCESS] Gigabyte Designare Z390 (Thunderbolt 3) + i7-9700K + AMD RX 580

[Feartech]

Attached.

SSDT-UIAC.aml should be removed as you already have a kext

 

[Inqnuam]

Attached.

@CaseySJ
I think he needs to create a fresh new EFI...

 

[CaseySJ]

Attached.

Although this alone may not fix the problem, it should be done nevertheless:

 

[CaseySJ]

@CaseySJ
I think he needs to create a fresh new EFI...


View attachment 521411

The timestamps on BOOTX64.efi and OpenCore.efi are correct (June 7). Not sure where that 0.6.3 is coming from. There are multiple disks in the system, each with EFI partition, so maybe the system is booted from the wrong disk?

 

[Inqnuam]

The timestamps on BOOTX64.efi and OpenCore.efi are correct (June 7). Not sure where that 0.6.3 is coming from...

Simple question:
@wiiwelshman have you restarted your PC after updating the EFI Partition ?

 

[luvlastcall]

I just copied your EFI folder to the EFI partition of a USB flash disk, copied my serial numbers into config.plist, and booted the computer with no issues. The OpenCanopy Picker says REL-070-2021-06-07, which is correct.

Please check the following:

• BIOS F9g or F9i

If problem persists, perform a CMOS Reset then configure BIOS parameters again, starting with F7 (Load Optimized Defaults). Remember to disable CFG-Lock from Boot section of BIOS.

Sure will try to do as instructed and update you accordingly

 

[Inqnuam]

@CaseySJ
I think he needs to create a fresh new EFI...


View attachment 521411

@CaseySJ Any idea what is the "PropertyInjector" kext ?

 

[luvlastcall]

I just copied your EFI folder to the EFI partition of a USB flash disk, copied my serial numbers into config.plist, and booted the computer with no issues. The OpenCanopy Picker says REL-070-2021-06-07, which is correct.

Please check the following:

• BIOS F9g or F9i

If problem persists, perform a CMOS Reset then configure BIOS parameters again, starting with F7 (Load Optimized Defaults). Remember to disable CFG-Lock from Boot section of BIOS.

Now getting this error airdrop is not working and BIOS version that I have is F9i and did everything as instructed and Planned to try the fresh installation and did that still there are so many issue that I have to check will share the information tomorrow please help me fix this issue

 

[CaseySJ]

@CaseySJ Any idea what is the "PropertyInjector" kext ?

Sounds like a third-party driver, but not one of our Hackintosh drivers. We also see UAFWAudio.kext, so it's possible that some of the issues are coming from these third-party drivers. But if they worked with previous version of OpenCore, they should continue to work with 0.7.0.

 

[CaseySJ]

Now getting this error airdrop is not working and BIOS version that I have is F9i and did everything as instructed and Planned to try the fresh installation and did that still there are so many issue that I have to check will share the information tomorrow please help me fix this issue

Regarding the OCS Schema warnings: Did you edit the config.plist file in OpenCore Configurator just now? If so, did you set OpenCore Configurator to 0.7.0 Release Version? It is necessary to use the latest version of OpenCore Configurator.