The Perfect Customac-Pro: X99-A II, i7-6950X, 128GB G.Skill TridentZ, Aorus GTX 1080 TI Xtreme

[gosss]

But there already has "Mac Pro 6.1 SMBIOS" in the right section i didn't have to change it maybe i forgot something?

thanks.

 

[kgp]

But there already has "Mac Pro 6.1 SMBIOS" in the right section i didn't have to change it maybe i forgot something?

thanks.

You said that you use SMBIOS iMac14,2 instead.. didn't you? How can I know if you forgot something from the two lines you write above?

 

[gosss]

I didn't have to change the product name, it was 6,1 already. , i just followed the idiot guide to put a serial number and the smUUID. So from the idiot guide , i just touched rt variable and smbios, nothing else, i didn't care about Imessage for exemple, have i to?

 

[kgp]

I didn't have to change the product name, it was 6,1 already. , i just followed the idiot guide to put a serial number and the smUUID. So from the idiot guide , i just touched rt variable and smbios, nothing else, i didn't care about Imessage for exemple, have i to?

Board serial number, serial number and SmUUID, that's all in case you just perform a clean install!

 

[gosss]

So it seems to working, i didn't have make the AGDPfix stuff yet.
i hope it will continue to work.

And another question my RAM is recognized at 2133Mhz but it is normally at 2666Mhz, how can i fix this.

Thanks a lot again for your help and your guide.

 

[kgp]

So it seems to working, i didn't have make the AGDPfix stuff yet.
i hope it will continue to work.

And another question my RAM is recognized at 2133Mhz but it is normally at 2666Mhz, how can i fix this.

Thanks a lot again for your help and your guide.

To overclock your RAM memory in concordance with your RAM specifications, enable the EZ XMP Switch on your ASUS Mainboard and enable posteriorly XMP in the Standard ASUS BIOS Setup mode (F7). Subsequently switch from standard to advanced ASUS BIOS Setup mode by pressing again F7.

 

[gosss]

Ok thanks, do i have to check "XMPDetection=YES" in boot section of clover configurator too? because mine is NO.

Thanks

 

[gosss]

For HWSensors, do i have to replace the fakeSMC.kext in the 10.12 folder with the one that is in the other folder of kexts.zip?

thanks

 

[gosss]

Another question sorry about this , do i have to install cudaDriver for my nvidia card? or just webdrivers are ok?

Thanks

 

[gosss]

Hi , does someone have an idea? when i connect my nvidia hdmi out, in the midle of the system load when we see the apple, my monitor becomes black and nothing else appear.

And with DVI it works. iwould like to put 2 screens .
Note that there is an adaptator hdmi -> DVI on the monitor side because it hasn't an hdmi input.
thanks in advance.