- Joined
- May 1, 2013
- Messages
- 18
- Motherboard
- Acer Aspire V3-771 (Clover)
- CPU
- i3-2328M/HM77
- Graphics
- HD3000/1600x900
- Mac
- Classic Mac
- Mobile Phone
Try patching DSDT according to guide...
http://www.tonymacx86.com/yosemite-laptop-support/152573-guide-patching-laptop-dsdt-ssdts.html
Not sure if it will help, but it can't hurt.
Patch with "HD3000 High Resolution" or "HD3000 Low Resolution" (eg. try both individually).
Also implementing backlight control may do something too.
You should also check your BIOS settings. And you can try injecting EDID.
Okay... I think I've made a mistake.
Yesterday I wanted to install Yosemite again. And I was able to boot into the installation only from the installed clover. Not from the Clover on my USB stick.
So I've installed Yosemite. Now, I'm not able to boot anything. Now I try to boot the installer again to make a fresh install.
It hangs at DSMOS has arrived and after comes this (see Image, booted only into verbose Mode)
Could you please help me, choosing the right bootflags? I've tried a few, but nothing works.