- Joined
- Aug 21, 2020
- Messages
- 45
- Motherboard
- Gigabyte Z390 Designare
- CPU
- i9-9900K
- Graphics
- << need model # >> See Forum Rules !!
Thank you very much.No problem. Please see attached.
Thank you very much.No problem. Please see attached.
I have tried but haven't found much. The ehtenet is also very slow but I used all the kext and files you had for download and followed your guide. Not sure what went wrong.Unfortunately I'm not familiar with the TP-Link T9E. This build guide recommends the Fenvi FV-T919 or FV-HB1200. Have you searched TonyMac or the Internet for possible solutions to this problem?
Try removing the TP-Link card (always shutdown and switch PSU off) then restarting and seeing if Ethernet speed is normal.I have tried but haven't found much. The ehtenet is also very slow but I used all the kext and files you had for download and followed your guide. Not sure what went wrong.
To switch to AMD GPU we can just install the AMD GPU and move the video cable to the AMD GPU.I used Clover for installation.
Did the jumper wire install & hot plug is back! And I have 40gb/s on both ports!If you don't see any renames there then no worries because there aren't any! Let's just try again without THB_C header cable, but this will require jumping together the middle and top pins of the J1 Thunderbolt header. Hold the card vertically with PCIe pins pointed towards the floor. Then jumper the middle and top pins with breadboard jumper wires (same types of wires as those used for flashing the controller).
Alright, that's certainly an improvement. Regarding video during boot, let's see if the HDMI/DP ghost plug solves the problem. Vendor name "Gigabyte" is correct because the GC-Titan Ridge is a Gigabyte product.Did the jumper wire install & hot plug is back! And I have 40gb/s on both ports!
Vendor name is still coming up as Gigabyte, I'm assuming that's ok?
Still no video during boot, but that's not the end of the world.
Going to reboot it with it still connected and see if it works on a reboot.
Cold boot still isn't happening when it's connected. But progress is progress!
Ok update time!Alright, that's certainly an improvement. Regarding video during boot, let's see if the HDMI/DP ghost plug solves the problem. Vendor name "Gigabyte" is correct because the GC-Titan Ridge is a Gigabyte product.
Nope. I removed the T9E wifi card and the ethernet speed is still really slow. I event tried both ports, but im using the one close to the audio ports as my main ethernet.Try removing the TP-Link card (always shutdown and switch PSU off) then restarting and seeing if Ethernet speed is normal.
Are you using Jumbo frames (large MTU value) on any other devices and/or Ethernet switches in your network? MTU setting is in:Nope. I removed the T9E wifi card and the ethernet speed is still really slow. I event tried both ports, but im using the one close to the audio ports as my main ethernet.