- Joined
- Oct 25, 2019
- Messages
- 61
- Motherboard
- Gigabyte Z390 Designare
- CPU
- I7-9700K
- Graphics
- RX 5700 XT
- Mac
- Mobile Phone
There might be something important I need to address in the Catalina Mini-Guide so let me ask some very specific questions:
If the answers to both questions are YES, then can I ask you to try the following experiment:
- With the config-Internal-GPU.plist file in the Catalina Mini-Guide, the Catalina installer was not able to start up fully? It got hung up shortly after gIOScreenLockState?
- With the config.plist created by UniBeast and subsequently modified by following the various spoilers in Post #1, the Catalina installer was successfully able to start?
- Open the config.plist you created from the Catalina Mini-Guide(not from Mojave) and just make one change:
- Clover Configurator --> Graphics --> Inject Intel --> check this ON.
- Then save the config.plist into CLOVER folder of Catalina USB install disk (in the EFI partition).
- Boot from the USB install disk.
- Does the Catalina installer start up fully?
- Don't worry, the installer will not make any changes to your installed system.
- If the installer starts up, just go to Apple menu and click Restart.
YES to 1. and 2.
But no, it does not change. Installer does not start up. Hangs with gIOScreenlockState 3
I got Catalina up and running with the config and the kexts from the initial guide combined with a Catalina USB Installer as described above but need to tweak a lot now. iGpu gives me headaches. When i change the fake id to 0x0, i get a black screen. If do the Framebuffer patching I get a kernel panic... jezz...