- Joined
- Feb 18, 2019
- Messages
- 358
- Motherboard
- ASUS Z690 Maximus Extreme
- CPU
- i9-12900KF
- Graphics
- 6900XT
- Mac
- Mobile Phone
Good day, @CaseySJ
Today, I intended to customize my own SSDT file by disabling port HS12 and enabling port HS08 with your
SSDT-UIAC-DESIGNARE-Z390-V7B.aml
to create SSDT-UIAC-DESIGNARE-Z390-V7D.aml in MasciASL for future upgrade purpose when I buy the CalDigit TS3 Plus, TB3 dock.
After I removed the V7B.aml and place my own V7D.aml in the patched folder, then rebooted it. iPad doesn't work and be recognized through Type-C cable connected to HS08 port (rear top Thunderbolt3/Type-C) when I looked it up in the USB section of Hackintools.
Could you point out what part of my file goes wrong, please? I used my old Macbook Air to edit the file in MasiACL. And I don't need HS12 port because it's already been taken by NZXT watercooler (9pin header) for only power supply not for file transfer purpose then it's useless to me by occuping one of the 15 ports just for power....
SSDT-UIAC-DESIGNARE-Z390-V7B.aml made by you - Success
Disable: HS10, HS11
Enable: HS01, HS13
SSDT-UIAC-DESIGNARE-Z390-V7D.aml made by me - Fail
Disable: HS10, HS11, HS12
Enable: HS01, HS13, HS08
HS08 does not need to be injected for USB-C to work on a TB3 port. USB-C is activated along with the TB3 port inside the TB3 SSDT. Besides, HS08 would only be useful for connecting a USB-2 drive (which makes no sense using a USB-C port; see the rear panel image on first post of this thread). Simply use V7B.
Also, the CalDigit TB3 dock, which I use, works perfectly fine CaseySJ's SSDT-UIAC; no mods needed.