- Joined
- Sep 14, 2010
- Messages
- 16
- Motherboard
- Abacax86 X99E-ITX
- CPU
- Intel i7 5820k
- Graphics
- EVGA 750Ti 3751-KR
hello,
i am trying to install Maverick using Clover on a brand new Brix GB-BXi5-4200 with a mSATA 60GB disk.
The install start with no problem but i get stuck at the end of the instalation preparation part of Mavericks with "About 0 seconds remaining".
That is where it should restart and then do the real installation.
I have tried diiferent Clover conf legacy or UEFI , but ends up all the time with the message.
anyone having this problem ? and hopefully a solution ?
UPDATE 1: i seems to work if i do the install on an external usb drive .... ill try to carbon copy clone teh partition afterward to the mSATA internal drive and let you know. i know this is only a workaround.
UPDATE 2: So Mavericks is working from the USB Hard Drive .. but my mSATA disk is not showing on diskutil ! it was showing when i tried the installation...
UPDATE 3: so i started again from the instalation usb stick .. then succed to partition/format my internal mSATA
then boot back on my mavericks install on the external usb hard drive where i can now see my mSATA drive
Carbon copy in progress
UPDATE 4: Everything is working
what have you done in order to get your sata or msata detected?