- Joined
- Aug 17, 2014
- Messages
- 139
- Motherboard
- HP EliteBook 840 G6
- CPU
- i5-8365U
- Graphics
- UHD 620
No. It is C++ code from the source code of Clover. Just confirming nguyenmac's assertion.
Alright.
No. It is C++ code from the source code of Clover. Just confirming nguyenmac's assertion.
You have to give me the troubleshooting files listed in #1 so I can investigate.
But you haven't given me the right one.
So now give me troubleshooting files again.
And here is the link for beta 5, if you want to test too:
https://www.dropbox.com/s/q5c4smzc2nrt99n/HP ProBook Installer Clover Edition 6.2.15 beta 5.zip?dl=0
...
Note: -gux_defer_usb2 does nothing when GenericUSBXCHI.kext is not installed.
You're right. I didn't follow the first post and send you my troubleshooting files. I'm sorry.
Question: How can I send you my troubleshooting files when OSX refuses to load after I run PBI?
I don't have BCM BT/WiFi... but Qualcomm Atheros QCA9565 Bluetooth 4.0 + HS Adapter, so, I gave up on: BrcmPatchRAM - Upload firmware into Broadcom Bluetooth USB devices The Guide is meant for Geeks.
I downloaded the BrcmPatchRAM.kext though, used KextBeat to install it to /S/L/E. Should I remove it?
Thanks.
EDIT: I checked /S/L/E and noticed GenericUSBXCHI.kext was not there, so I downloaded it and installed it using KextBeast.
You have to give me the troubleshooting files listed in #1 so I can investigate.
But you haven't given me the right one.
So now give me troubleshooting files again.
And here is the link for beta 5, if you want to test too:
https://www.dropbox.com/s/q5c4smzc2nrt99n/HP ProBook Installer Clover Edition 6.2.15 beta 5.zip?dl=0
I completely wiped my drive and started at true absolute zero.
After installation, I restarted, and Yosemite Started.
I ran PBI beta 5 without the config and dsdt patch. restarted.
I ran pbi beta with config and dsdt path. Restarted.
I then did the same two steps with beta 6.
It seems to be all working now.
Should I brave the new PBI update?
Should I update clover at all?
No, Post your EFI/CLover folder (Only Clover folder) for beta 5.
Then, *if you want to help me fix this model in PBI CE*, backup your EFI folder (beta 5), install beta 6.
If system can't boot again:
- Rename EFI folder beta 6 and replace by beta 5.
- If you can boot now, post your EFI folder beta 6.
Successful on beta 6. Now maybe I can get back around to figuring out the track pad issue from my other thread.