- Joined
- Jan 29, 2019
- Messages
- 4
- Motherboard
- Intel NUC8i3BEH1
Alright, this ^^^ appears to be related to 10.14.3, you need to use either 10.14.1 or 10.14.2 or else this will happen
- The second is that in the install guide, I understood that you need to type this complete string into Terminal :
In reality for it to work you need to first run :Code:./download.sh ./install_downloads.sh
And then :Code:./download.sh
Code:./install_downloads.sh
- Changing FakeID to the value that it should be instead of the dummy value
Thank you so much for your reply!@RehabMan and the other developers have been unable to get it to work on the NUC8i. I'm not sure if it's on everybody's agenda atm, tbh... At least USB-C [somewhat] works! Attached is a picture of what should be showing, if Thunderbolt controller was detected and working (note, from my 2012 Macbook Air):
@TR01 Did you ever find a solution? I have tried different versions of OsxAptioFixDrv-64.efi (2,3,-2000) with no difference. I really want to have a solution that will allow the computer to reboot into desktop after power-outage, etc. Using this for a Security camera solution using Bensoftware SecuritySpy. Not good that it can't recover from power-outage -power-restore.@BillyGoatGruff
That seems to be about the same for me after playing with it for a few days, but I'm not dual-booting. It's pure hackintosh - and a fast one, when it boots.
I just wish there were a tuneable to allow it to boot every single time with no problem.