[Guide] HP Elite 8300 & 6300 Pro (all form factors) using Clover UEFI hotpatch

[Giovo17]

Giovo17,

I have seen the boot loop with the IGPU misconfigured. Could you check if the IGPU is enabled
in BIOS, and if so, whether it is set to be the Primary or Secondary? Are you using the config2500
plist renamed as config.plist?

I think the GPU is disabled from the BIOS (take a look at the picture, I'm not sure I went to the right section) and yes, I'm using config2500.plist as config.plist

 

[Asural]

I'm using config2500.plist as config.plist

Installation-> Step 2: Did you format the HDD with APFS in Step2?

 

[Giovo17]

Installation-> Step 2: Did you format the HDD with APFS in Step2?

No, I miss this step... I'm trying with apfs filesystem

 

[Giovo17]

Installation-> Step 2: Did you format the HDD with APFS in Step2?

Tried in APFS, but I have the same problem

 

[Asural]

Tried in APFS, but I have the same problem

After the Installation-> Step 2 is completed, the Clover Menu screen appears, and the USB Disk and the Install Disk are displayed.
Before selecting the installation disk, press the Space key and select Vapose mode.

Is it abnormal here?

 

[Giovo17]

After the Installation-> Step 2 is completed, the Clover Menu screen appears, and the USB Disk and the Install Disk are displayed.
Before selecting the installation disk, press the Space key and select Vapose mode.

Is it abnormal here?

I'm not finding any "vapose mode"...

 

[Feartech]

I'm not finding any "vapose mode"...

Verbose

 

[Asural]

Verbose

ya, ty

sorry "Verbose (-v)"

 

[Giovo17]

ya, ty

sorry "Verbose (-v)"

Same problem, nothing changed. If you want I can share my EFI/Clover folder, maybe the problem is there

 

[Asural]

Same problem, nothing changed. If you want I can share my EFI/Clover folder, maybe the problem is there

Check the guide again.
The configuration of Clover r5013 should be as follows.

Add: VirtualSMC.efi is not required, please use VirtualSMC.