- Joined
- Sep 8, 2014
- Messages
- 3
- Motherboard
- Mavericks 10.9.1
- CPU
- i5 2500K 3.31Ghz
- Graphics
- GeForce 8400GS 512mb
- Mac
- Classic Mac
- Mobile Phone
I recently installed Mavericks 10.9.1 using Unibeast and then Multibeast.
Everything works great except that during the installation, so when I boot from the memory stick and even now post installation, I get a black screen after the Apple logo. The monitor loses signal and goes on stand by mode.
I went through a few threads of people getting black screen after the Apple logo but they all seem to say that they get that every time. I get that sometimes, I would say about 60% of the times.
So if I turn my computer off and on again a couple of times everything works fine.
I tried entering different bootflags that people suggested from other threads. For example I tried GraphicsEnabler=Yes, and it worked. But when I tried the next time it didn't.
I suspect this is a problem with Graphics Card as it is quite old but why does it happen only sometimes?
Can anyone help? My spec are in my profile.
Everything works great except that during the installation, so when I boot from the memory stick and even now post installation, I get a black screen after the Apple logo. The monitor loses signal and goes on stand by mode.
I went through a few threads of people getting black screen after the Apple logo but they all seem to say that they get that every time. I get that sometimes, I would say about 60% of the times.
So if I turn my computer off and on again a couple of times everything works fine.
I tried entering different bootflags that people suggested from other threads. For example I tried GraphicsEnabler=Yes, and it worked. But when I tried the next time it didn't.
I suspect this is a problem with Graphics Card as it is quite old but why does it happen only sometimes?
Can anyone help? My spec are in my profile.
