Can't boot into Mavericks without safe mode, verbose mode, and USB

[xanthehammer]

Hi, this is my first hackintosh. I installed Mavericks with the Unibeast USB method. After that I ran Multibeast and everything works fine except for booting up. When I boot up I have to boot from the flash drive and use verbose mode, safe mode, and set PCIRootUID=1. If I boot from the hard drive I get the boot0 error. I followed all the directions on the guide to fix the boot0 error down to each letter but I still have had no luck. I'm positive I installed everything correctly. I've spent many hours on end trying to fix this and trying other people's solutions but nothing is working. Any help would be much appreciated. I've been able to fix every other problem I've run into by myself but no luck with this one.

My build:
Gigabyte H87M-HD3
Intel core i5 4590r
Seagate 1TB HDD
Crucial Ballistix Sport 8GB Kit (4GBx2) DDR3 1600 MT/s

I'm letting the CPU do the graphics for now


Thanks!
-Xanthe

 

[mun35]

Have you got a USB drive connected?

 

[R3D]

Hi,
sorry for the intrusion.

I've almost your configuration, but i'm stuck in installation process :
GA-H87M-HD3
i5-4570
Crucial Ballistix Tactical 8GB Kit (4GBx2) DDR3 PC3-14900
Crucial MX100

I've updated the bios with F8 revision, i'm connected in DVI, i'm using one stick of ram, after reading many posts, i've tried multiple combination of boot flags -x -v maxmem=2048 etc
But i'm still getting kernel panic or freeze and cannot complete install.

Could you describe your settings and the steps / commands that you ran for the installation?

Or if someone can help to give some advice,
Any help would be greatly appreciated!

Thanks

R3D