- Joined
- May 11, 2013
- Messages
- 6
- Motherboard
- Dell Optiplex 9020 MT
- CPU
- i7-4790
- Graphics
- RX 580
- Mac
- Mobile Phone
Why are you disconnecting the monitor after booting ?If I disconnect the monitor after booting and reconnect it I get no signal and the monitor goes to sleep.
Limited number of available monitors, limited space on my desk, limited input ports on the monitors. Poor mans way to switch between computers I guess.Why are you disconnecting the monitor after booting ?
So you're adapting onboard DP to VGA ? Or DP to HDMI ?Limited number of available monitors, limited space on my desk, limited input ports on the monitors.
Sorry, I forgot to explain that earlier. I've been using the DP port next to the VGA port. The cable goes from DP to DVI.So you're adapting onboard DP to VGA ? Or DP to HDMI ?
I will be interested in your results. Here is a post I made on my approach. Dell Optiplex 9010 MT mod use GPU covered PCIe 1x slot. The 9010 MT is slightly different, but the idea is the same.Hi folks,
I recently got interested to install M.2 PCIe NVME adapter on my Optimac 9020 MT. As you know, PCIe x1 is not available if you install a certain size GPU in PCIe x16. Also, my PCIe x4 has Fenvi WiFi+Bluetooth card. So, I ordered 90 degrees angled PCIe x1 extender in order to see if I can move Fenvi to PCIe x1 in an empty PCI slot with the extender and install the NVME adapter in PCIe x4. It takes 3 weeks to be delivered, but I'll keep you folks posted (hope anybody is interested...).
PCIe x1 angled extender
if it booted fine before, then best re check your bios settings againI needed help again
I changed the BIOS battery today as I did not have one last time but now I can't start Mac OS