Hi
@CaseySJ
Sorry for the double post but I posted last week and I think my post was missed due to not tagging you.
I've build a rig a while back and have a good setup going on Catalina, though haven't followed the thread as much recently. I was on Clover but recently switched to Opencore following your guides. However, I now seem to have trouble booting at times. During the boot process in verbose mode, everything goes through until it tries to jump to the Catalina login screen. At that point, the screen goes blank afterwards and it doesn't proceed to the Catalina login screen. I have tried resetting the CMOS/BIOS and that didn't help but then I disabled internal graphics in the BIOS settings which seems to work, but this goes against what your recommended BIOS settings are. Do you have any thoughts about this? Are there any other settings I need to change to enable internal graphics?
I'm not sure if this is the problem, but I recall I set the platform ID to headless when I initially installed Catalina with Clover, though now it is just 0x00000000 on Hackintool. Are there different directions to set it to headless on Opencore?
Thank you very much!