@CaseySJ ,
Hi again,
I finally removed every part of the Computer one by one.
It appeared the Fenvi-T919 was causing the PC to BootLoop. When removed it will do its post test then Boot normally and even shutdown normally.
However it is strange, that with the Fenvi Plugged,
once you wait 4-6 hours of shutdown, the computer will work, at the first boot (not the second one).
It will run the POST and run, the Fenvi working perfectly (WiFi and Bluetooth).
If you shut it down, it will boot loop forever (until you wait 4-6h).
This problem can be solved by removing instantly the Fenvi, which will allow the computer to Boot.
Is there anyone which had the same problem here ?
I’m hesitating buying a new brand one Fenvi-T919. Could it be a support/conflict hardware problem ?
I can’t remember but you where talking about allowing the Intel WiFi/BT card to be displayed on Mac.
Is that a good solution or do you advise me to buy a new one ?
Should I buy a new one or just maybe change the brand.
What is the best WiFi/BT card supporting MacOS available nowadays ?
thank you