- Joined
- Nov 16, 2019
- Messages
- 209
- Motherboard
- Gigabyte Z390 Designare
- CPU
- i7-9700K
- Graphics
- RX 5700 XT
- Mac
- Mobile Phone
Just tried a fresh install again @CaseySJ. I still got a CPU halted, and it shut down. I've attached a video of the Verbose fully and of the Clover folder. I got thru the install completely. It was, when I tried to boot the welcome GUI, that it halts. I am able to get thru install GUI, both boots and then not into the welcome for some reason.
I installed on a new NVMe. I flashed the BIOS to f8 clean.
I set up the BIOS settings from post 1.
I created new USB installer with 10.15.2.
I used Clover 5100.
I installed with option.
I used newest fresh install folder info.
Config with AMD gpu config file
I added the serial to SMBIOS & Rtvariables.
Also tried with/without XMP.
Any idea what could be causing all this?
Just in case the video is hard to see, I believe this is all the verbose that shows.
I installed on a new NVMe. I flashed the BIOS to f8 clean.
I set up the BIOS settings from post 1.
I created new USB installer with 10.15.2.
I used Clover 5100.
I installed with option.
I used newest fresh install folder info.
Config with AMD gpu config file
I added the serial to SMBIOS & Rtvariables.
Also tried with/without XMP.
Any idea what could be causing all this?
Meet Google Drive – One place for all your files
Google Drive is a free way to keep your files backed up and easy to reach from any phone, tablet, or computer. Start with 15GB of Google storage – free.
drive.google.com
Just in case the video is hard to see, I believe this is all the verbose that shows.
Attachments
Last edited: