- Joined
- Nov 5, 2010
- Messages
- 26
- Motherboard
- GA-P55A-UD3- F11
- CPU
- i5
- Graphics
- EVGA GeForce GTX 760
- Mac
Hi all,
I have had my setup for about 4-5 years and now want to make the switch to Clover...I have created a Unibeast USB before and have not had any problems. When I use Unibeast 6.0 it creates a USB drive. When I try to load the Clover installer the computer turns on and stays stuck on the Loading Operating System screen. There is no spinning dash...It just stays stuck...I have tried formatting the USB as GUID like suggested and then as Master Boot Record, but neither works...I have had my Bios set the same through all previous installs, so I don't think I am missing anything there.
Here are my specs:
Motherboard: Gigabyte GA-P55-UD3
CPU: 2.93 Ghz Intel Core 5
Graphics: Nvidia Geoforce GTX 760 2048 MB
Hard Drive: SSD 500 GB (+ 2 1 TB hard drives and 1 500 GB Harddrive)
Memory: 32 GB 1333 MHz DDR3
OS: Yosemite 10.10.3
Thanks!
I have had my setup for about 4-5 years and now want to make the switch to Clover...I have created a Unibeast USB before and have not had any problems. When I use Unibeast 6.0 it creates a USB drive. When I try to load the Clover installer the computer turns on and stays stuck on the Loading Operating System screen. There is no spinning dash...It just stays stuck...I have tried formatting the USB as GUID like suggested and then as Master Boot Record, but neither works...I have had my Bios set the same through all previous installs, so I don't think I am missing anything there.
Here are my specs:
Motherboard: Gigabyte GA-P55-UD3
CPU: 2.93 Ghz Intel Core 5
Graphics: Nvidia Geoforce GTX 760 2048 MB
Hard Drive: SSD 500 GB (+ 2 1 TB hard drives and 1 500 GB Harddrive)
Memory: 32 GB 1333 MHz DDR3
OS: Yosemite 10.10.3
Thanks!