- Joined
- Jan 31, 2022
- Messages
- 41
- Motherboard
- Gigabyte z390 Designare
- CPU
- i9 << need model # >> See Forum Rules !!
- Graphics
- 6900xt
doneTry loading the UAD Kext from terminal.
doneTry loading the UAD Kext from terminal.
If you still have your old GPU or another one which is supported by Catalina then put it back, install Catalina back and check if TB still worksDo you think it would be easier if i buy a PCi thunderbolt card ?
Unfortunately notIf you still have your old GPU or another one which is supported by Catalina then put it back, install Catalina back and check if TB still works
Did you ever figure this out?I am using Ultrafine 5K monitors. Hot Plug working well in Z390 Designare. but Not in this board X299 EX Designare. Monitor is on but No USB functionalities like camera, audio, brightness control. Z390 board works well with it after hot-plug applied. The thing I want to have hot plug working in this board is about after sleep/wake. After wake from sleep, all the USB functions not working like I told. I used Z370 with Alpine ridge and Z390 Designare with SSDT. And those boards were working fine with the monitors USB functions after sleep/wake. Only cold boot in X299 board, makes USB functions back.
...you have an integrated GPU, so remove the 6900 and try it.Unfortunately not
Are you using the GC-Titan Ridge card? If so, NVM33 is a good option.Did you ever figure this out?
After two years, i've never managed to get TB properly working.
@CaseySJ I think that the SSDT for the X299 Designare EX might need some more work. Would love to help if possible. Also, what firmware would I use, if I were to try and flash the card?
No, I'm still just trying to get the the onboard Alpine Ridge JHL6540 controller working.Are you using the GC-Titan Ridge card? If so, NVM33 is a good option.
I don't use any of these on my end, I don't think the problem comes from external drivers, especially since I experienced the same problem on a fresh install.I am also keen on determining what the culprit might be. My system has a 6800 XT. In addition, the following apps have installed their own drivers:
- Paragon NTFS for Mac
- SoftRAID 6.x
- Parallels 7.x
I don't recommend flashing Alpine Ridge cards because that doesn't seem to improve reliability. Some questions:No, I'm still just trying to get the the onboard Alpine Ridge JHL6540 controller working.
Honestly, I don't even need HP to work. I just need my devices (OWC TB3 dock & G-RAID) to stay connected reliably, especially after wake.
I don't recommend flashing Alpine Ridge cards because that doesn't seem to improve reliability. Some questions:
- Which SSDT are you using now?
- A simple one that just enables hot plug?
- A complex one that also enables Thunderbolt Bus?
- Do the OWC TB3 dock and G-RAID drive connect and work when Thunderbolt Bus is not enabled?
- After a wake-from-sleep, what exactly happens?
- Does the OWC Dock reappear in IORegistryExplorer?
- Does the G-RAID reappear in IORegistryExplorer?
- If only the drives disconnect after wake-from-sleep, have you considered trying something like the Jettison app from St. Claire Software?