Success: Coffee Lake i7-8700K - GA-Z370N-WIFI

[fontanero]

 

[noob23]

how did you swap the wifi component on this motherboard? I bought the same one but cannot figure it out... thanks in advance!

 

[fontanero]

Adapter to WIFI+BT card: https://www.ebay.es/itm/BCM94360CS2...a-Mac-OS-SG-/232546964478?hash=item3624e113fe

WIFI+BT card: https://www.ebay.es/itm/Apple-MacBo...Card-/253268775818?hash=item3af7fed38a&_uhb=1

 

[noob23]

@mille1j

Do you know if this motherboard will work with a PICO PSU with a 4-pin power connector (instead of the 8-pin one), as long as the processor and other components are below the 160 Watts this PSU provides?

Also, could you upload the SSDT for the USB ports that you created?

did you ever get an answer to this question. I too have a 4 pin psu however the sum of all my components are less than 160 Watts.

 

[fontanero]

did you ever get an answer to this question. I too have a 4 pin psu however the sum of all my components are less than 160 Watts.

That's how mine is working, and very well.

 

[fontanero]

Hi, my PSU 160W
External adapter Input-110-220Vac 3A-50/60Hz output: 12v-12,5A 150W
Perfect...

 

[fontanero]

did you ever get an answer to this question. I too have a 4 pin psu however the sum of all my components are less than 160 Watts.

Yes, you can load USB SSDT, is for this motherboard independent of the rest of the hardware.

 

[fontanero]

did you ever get an answer to this question. I too have a 4 pin psu however the sum of all my components are less than 160 Watts.

Yes, you can load SSDT, is for this motherboard independent of the rest of the hardware.
You only need this in EFI:



and USBInjectAll.kext in /Library/Extensions/

 

[SuX0rz]

This worked for me. Thanks!

There is a fixed to this that works for me and others. It is discussed here:
https://www.tonymacx86.com/threads/...p-with-xmp-enabled.251488/page-2#post-1848006

Essentially, you have to use XMP detection in Clover while turning it off in the BIOS.

 

[maricn]

I attached EFI and Extensions folder.

I have tried using your attached files, but I have flickering on my setup. It recognizes 630 and 2GB virtual memory, but it's flickering heavily.
I tried updating clover using Clover Configurator, which, unusually doesn't boot (even if I only update Clover itself).
I tried using this kind of config separately and applied on top of your EFI and Extensions. Recognizes 630, but shows only 7MB of virtual memory, and some applications don't render properly.
I tried using newest versions of the kexts you are using and replacing them in EFI, in /S/L/E and /L/E. Doesn't boot.
I tried removing your hp_* kexts. No difference.

Any suggestion? Thanks!

EDIT: I'm using 18,2 instead of your config, and I removed Kaby Lake patch from it.