- Joined
- Mar 23, 2011
- Messages
- 20
- Motherboard
- Gigabyte GA-Z97X-UD7 TH
- CPU
- i7-4970K
- Graphics
- GTX 760 (x2)
Hi there,
I have Catalina 10.15.3 installed on a HP Z220 workstation with a Samsung Evo 850 SSD.
I'm using the integrated Intel 4000 graphics.
All boots up and works normally, however there is a long delay during boot for some reason.
Please see my video to see what happens:
It seems to hang for a bit at spaceman_trim_free_blocks and then for a significantly longer time at GTrace synchronization point 5.
After hanging there, it continues booting in at full speed.
I tried with or without Trim and it makes no difference.
I'm only using FakeSMC.kext and IntelMausiEthernet.kext at the moment. I tried Lilu.kext and VirtualSMC.kext but the behavior is the same. I'm utilising these under EFI/Clover/Kexts/Other.
I attached my clover config.
Any idea what could be causing this issue?
I have Catalina 10.15.3 installed on a HP Z220 workstation with a Samsung Evo 850 SSD.
I'm using the integrated Intel 4000 graphics.
All boots up and works normally, however there is a long delay during boot for some reason.
Please see my video to see what happens:
It seems to hang for a bit at spaceman_trim_free_blocks and then for a significantly longer time at GTrace synchronization point 5.
After hanging there, it continues booting in at full speed.
I tried with or without Trim and it makes no difference.
I'm only using FakeSMC.kext and IntelMausiEthernet.kext at the moment. I tried Lilu.kext and VirtualSMC.kext but the behavior is the same. I'm utilising these under EFI/Clover/Kexts/Other.
I attached my clover config.
Any idea what could be causing this issue?
