- Joined
- Feb 27, 2016
- Messages
- 4
- Motherboard
- Gigabyte GA-Z97X-UD5H
- CPU
- i7-4790
- Graphics
- GeForce GTX 970 4GB SSC
- Mac
- Mobile Phone
I recently updated from Sierra 10.12.4 to 10.12.5. I had some issues booting so I futzed around a bit then finally found the updated web drivers from nvidia. Now I can boot but have terrible performance and large sections of my screen continue to re-render (shown in the imgur link below). Also note that only one of my two monitors is receiving signal. Not sure what I messed up but I now know to make a backup before updating...
http://imgur.com/a/qkf0o
Also shown in the link is my config.plist with NvidiaWeb set to true, my NVIDIA Driver Manager screens with latest version of the web drivers installed and NVIDIA Web Driver enabled (not shown is the ECC tab listing 'no device found' for all four slots), my 'About This Mac' which shows Sierra 10.12.5 installed and system definition as iMac late 2013.
The machine was set up with Multibeast with the following configuration. After the update failed I loaded this config and installed again to no avail: https://www.dropbox.com/s/0ntaoe12e8plm7e/MultiBeast_Config2.mb?dl=0
edit: Direct link to config.plist below; apparently I uploaded the wrong plist previously!
My EFI: https://www.dropbox.com/s/vtndz8puhlv2z71/EFI.zip?dl=0
What other information can I provide? Any suggestions? Thanks for reading!
http://imgur.com/a/qkf0o
Also shown in the link is my config.plist with NvidiaWeb set to true, my NVIDIA Driver Manager screens with latest version of the web drivers installed and NVIDIA Web Driver enabled (not shown is the ECC tab listing 'no device found' for all four slots), my 'About This Mac' which shows Sierra 10.12.5 installed and system definition as iMac late 2013.
The machine was set up with Multibeast with the following configuration. After the update failed I loaded this config and installed again to no avail: https://www.dropbox.com/s/0ntaoe12e8plm7e/MultiBeast_Config2.mb?dl=0
edit: Direct link to config.plist below; apparently I uploaded the wrong plist previously!
My EFI: https://www.dropbox.com/s/vtndz8puhlv2z71/EFI.zip?dl=0
What other information can I provide? Any suggestions? Thanks for reading!
Attachments
Last edited: