Multibeast and Z77-DS3H with GT 440, black screen after some booting

[vladkorotnev]

Hello everyone.
I have built a hackintosh on i3-2120 (see profile) and made a usb with Unibeast on my Macbook pro but when I try to boot it, it does everything as usual but EXACTLY as the Ethernet driver loads (? the line with MAC address pops up) the screen goes blank on both the GT440 and obviously on the disabled internal graphics.
What is the problem?
Singleuser works fine until i proceed with 'exit'.
Tried booting with all possible combinations of: -v -f -s -x GraphicsEnabler=No PCIRootUID=0 cpus=2

 

[vladkorotnev]

As I said, i can't because it disappears instantly. Here is a video of booting with '-v', though: http://www.youtube.com/watch?v=GASiMchA4yg

 

[rlf156]

The i3-2120 processor has HD2000 graphics which won't work on OSX. You can make it work in VESA mode if you delete a bunch of the AppleIntel drivers. In VESA mode, you do not have resolution control or hardware acceleration.

Connect the internal graphics to the monitor.

Boot in single user mode (-s). This is a textual environment. When you see the prompt "root", then

Type:  mount -uw /
Type:  cd /System/Library/Extensions
Type:  mkdir backup
Type:  mv AppleIntelF* AppleIntelH* AppleIntelI* AppleIntelS* backup/
Type:  cd ../
Type:  touch Extensions
Type:  reboot

 

[vladkorotnev]

Thanks folks, resolved everything with Natit and '-v npci=0x2000 darkwake=0 PCIRootUID=1'
Topic can be closed now.
I am back into the world of Hackintosh