- Joined
- Apr 18, 2011
- Messages
- 1,492
- Motherboard
- ASUS Pro WS X299 Sage II
- CPU
- i9-10980XE
- Graphics
- W5500
- Mac
- Mobile Phone
I will mess with that here later in the week. Thanks again!
Let me know what you find out!
I will mess with that here later in the week. Thanks again!
OKAY will the GPU work in Slot 3? I have always heard that you need GPU in Slot One. I have a test with this system today so no Thunderbolt for now.
Nope slot-2, check 3.6.12 section of the manual. Kinda sucks but I have my gpu in slot 1 on a riser card until I watercool and make it a single slot card. Also the thunderbolt header is right below slot 2
update is all good!
Is thunderbolt 3 working fine on Deluxe II? Anything that I should be aware of if I want to make a new build with this motherboard and one of the refresh CPUs?
yes, Alpine Ridge XHCI WA
no, i dont want TTR ports to pop up under HS09/10... i just test and find it will for some cases.
no Alpine Ridge, just the JHL7540 on board.
View attachment 384119View attachment 384120View attachment 384121
hi Guys! Could someone help me? do not get the install usb to start
Hardware:
i9 7900x on asus rampage 6 extreme with the latest bios and a rx580 8gb
I've gone through the instructions point by point.
then I start clover select install from usb. everything loads normally and after 1 minute turns off the screen but the pc continues to run normally
Hi @kgpWell when trying to fully implement the entire TB-SSDT dumps of a real iMacPro or MacBook Pro 2018 to also likely achieve a proper local TB node and TB Bus driver implementation, we reached the conclusion that the latter might be only possible based on the EPROM implementation on a real iMacPro (Alpine Ridge) or MacBook Pro 2018 (Titan Ridge) and some subsequent implementation of the respective information in Clover, if possible at all.
Anyway, good luck for your endeavours, wherever you reach..