- Joined
- Mar 22, 2013
- Messages
- 40
- Motherboard
- Gigabyte Z490 Vision D
- CPU
- i7-10700K
- Graphics
- RX 5600 XT
- Mac
- Mobile Phone
Yup.. It was completely empty.Have you emptied your trash?
This is what I got:
Yup.. It was completely empty.Have you emptied your trash?
There is only 24MB left. Although the ZIP is 7.8 MB, it's better to delete older EFI folders or move them to the main SSD.
If you're using iMac19,1 it may be good to try temporarily switching to iMacPro1,1 or even MacPro7,1 (but MacPro7,1 may require MacProMemoryNotificationDisabler.kext (attached). iMacPro1,1 is the safer of the two options to try first.Hi! I´m back with new questions...
I´m wondering if there´s any kext I could try to boost my radeon 5600xt card.
I´ve been using cinema4d and prorender to test some 3d renders and I´m getting 2 minutes 50 seconds per frame in a scene on OSX (using metal) and 1:40 for the same scene in Windows (using openCl). If I use just OpenCl in OSX the render time reduces to 2:09.
Any help will be appreaciated!
I am not sure I am reading your EFI folder correctly but I would completely delete everything in the EFI folder. Empty trash and then check info again and see if everything is free. I you have 206MB available, then you should be good to go with your replacement EFI. If there is still only 24mb free then there must be something hidden in the folder.
I have been having the same problem. I did get in touch with Gigabyte but I have not heard back from them. I also had this same problem with my Designare. After reading that people were having trouble with the Fenvi T919, I disconnected the Bluetooth USB cable and the machine started booting quickly into Catalina. (It was hanging on code 64 which can be usb related.) Today I replaced the T919 with the Fenvi 1200 and so far it seems ok. Don't know if it is a compatibility issue or if my card was bad. Once booted the BT and Wi-Fi did work properly.Moving to another problem, I am getting regular hangs at the Gigabyte Splash Screen which I recover from by doing a Reset and Reboot or a Power Down and Reboot. I have even had to do a Clear CMOS on a couple of occasions.
Any idea what may be causing this as it is somewhat frustrating not knowing if my Hackintosh is actually going to boot successfully?
I tried doing that but it didn´t work.. I ended up going to recovery mode and copying my entire EFI from the USB drive to the one inside the SDD and that worked perfectly. The command used was dd if=/dev/disk1s1 of=/dev/rdisk0s1I am not sure I am reading your EFI folder correctly but I would completely delete everything in the EFI folder. Empty trash and then check info again and see if everything is free. I you have 206MB available, then you should be good to go with your replacement EFI. If there is still only 24mb free then there must be something hidden in the folder.
SLN9D on Vision G (at least in the early board releases).
Photos from two different reviews of Vision G:
2.5GbE Intel I225-V V2 (SLNJY) compatibility issue still exists - Only 1Gbps with NETGEAR Switch
No got a Philips 40" 4k. I believe that it is relate to the AMD graphic card since before the 5600XT I had an old Nvidia 660GTX and it never happenedDo you also have an LG 4K monitor?