- Joined
- Mar 6, 2014
- Messages
- 27
- Motherboard
- Asus X750JB
- CPU
- Intel Core i7 4700HQ
- Graphics
- Intel HD Graphics 4600 + GeForce 740m
Hey guys, I've come across a tough issue. I followed this guide and came across an issue while launching the OS X installation via clover, shown in the picture provided. Please consider that I've already tried using "dart=0" in the boot flags option, booting in safe mode, tried all of the applicable solutions provided in the "Big List of Solutions for El Capitan Install Problems", used my 650 Ti instead of my 980 Ti, followed this guy's tutorial (while using OsxAptioFixDrv-64.efi instead of the "Fix2" version), I've even tried putting both on at the same time.
I realize that I am using a newer, high-end rig that might run in to more problems than a normal OS X installation, but this is crazy, the only thing I can think of now is looking into the memory address the error describes and maybe fix up Clover via source (which I don't have any clue on what to do)
Also, the "Fix1" version of the Aptio .efi file gives me:
OsxAptioFixDrv: AllocateRelocBlock(): can not allocate relocation block (0x16687 pages below 0x100000000)
"16687" could be anything, and the "Error allocating 0xXXXXXX" changes depending on where the USB is. I'm using a USB v3 stick on USB 2 ports, which should work, though I am trying it on a USB v2 stick, and I'll reply on how it goes when it's done; I've also replaced the "VBoxHfs-64.efi" with "HFSPlus.efi," based off of general experience.
Any suggestions would be greatly appreciated. The specs of my build should be on my profile and I've attached my EFI folder for those who want to see what's specifically inside. View attachment EFI.zip
I realize that I am using a newer, high-end rig that might run in to more problems than a normal OS X installation, but this is crazy, the only thing I can think of now is looking into the memory address the error describes and maybe fix up Clover via source (which I don't have any clue on what to do)
Also, the "Fix1" version of the Aptio .efi file gives me:
OsxAptioFixDrv: AllocateRelocBlock(): can not allocate relocation block (0x16687 pages below 0x100000000)
"16687" could be anything, and the "Error allocating 0xXXXXXX" changes depending on where the USB is. I'm using a USB v3 stick on USB 2 ports, which should work, though I am trying it on a USB v2 stick, and I'll reply on how it goes when it's done; I've also replaced the "VBoxHfs-64.efi" with "HFSPlus.efi," based off of general experience.
Any suggestions would be greatly appreciated. The specs of my build should be on my profile and I've attached my EFI folder for those who want to see what's specifically inside. View attachment EFI.zip
Last edited: