Recent content by mivanovic

Thanks UtterDisbelief for your reply. You probably misunderstood my initial question... I haven't created any custom USB mapping yet. My problem is that even when I use patches and USBInjectAll.kext and when I set XHCIPortLimit to TRUE, I don't see more than 16 usb ports. My main concern is that...

If you haven't noticed, all those port-limit removal patches are deactivated: enable=FALSE; Why do you think that my config.plist is hybrid? I have used only Proper Tree app for editing... I am ready to reinstall my PC again. Do you recommend Open Core or Clover? Thanks.

In the OC guide only those 4 aml drivers were sufficient. There was no mention of SSDT-UIAC.aml. And my system boots fine, the only issue I have is USB ports... Please advise what would be best to do. Should I create new Clover based EFI?

Thanks for your reply. So, what do you suggest?

Hi all, after couple of days researching and unsuccessful implementation of different guides from this forum to make my BT working, I have decided to write this post and to provide all specific details in my case. My build: mobo: Gigabyte Z390 aorus ULTRA CPU: Intel Core i5 9600K (with iGPU in...

Hi Humanate, thanks for your help and efforts. Here is a copy of my current EFI folder.

Yes, I have added VirtualSMC.kext to my Config.plist under Kernel > Add. What about VirtualSMC.efi driver? Do I have to add it to Config.plist , too? Which Sensor kexts should I add to Kext folder?

What is the process in case of using OpenCore bootloader?

Can someone please help? When I add VirtualSMC.elf driver and sensor kext files to my OC Kext folder, I am not able to boot my computer. I get critical error at the very beginning of the boot process.

Hi all... I have an issue with sensors identification. I use OpenCore bootloader and my PC is working fine excepet the fact that iStat Menus monitoring app doesn't see my sensors. I do have VirtualSMC.kext installed, however I don't have sensor kexts. When I just added sensor kexts to my KEXT...

I have enabled mu iGPU in BIOS, but how I can verify if my iGPU will be used? My iMAC def is 19,1.

Hi all, I hope someone can help me with my request... I successfully managed to build my Hackintosh ( Gigabyte z390 Aorus ULTRA, Intel Core i5 9600K (with intel graphics 630), Sapphire Radeon RX 580 Pulse 8 GB, 16 GB Corsair RAM...). I have used OpenCore 0.5.7 as a bootloader and my machine is...

I have been using Focusrite Saffire PRO 14 for years on my iMAC via Firewire. Now, I don't have FW port on my Gigabyte Z390 Aorus ULTRA mobo, so I wonder would it be better to buy PCI card with Firewire ports, or to switch to USB (3.0 or 3.1) audio interface ( which means I need to buy new one)...

When I try to boot from HDD at around 75% of booting process, I get black screen. I can't even boot it with USB Mojave when I set Sapphire Radeon RX 580 as my primary GPU. Booting is going fine and around 75% I get a black screen again. I am not sure what I need to do.

Hi all, I hope someone already had similar situation... My build: mobo: Gigabyte Z390 Aorus ULTRA CPU: Intel Core i5 9600K GPU: integrated Intel 630 SSD: Crucial P1 500 MB M.2 RAM: Corsair DDr4 Vengeance RGB Pro 2x8 GB 3200 I have successfully installed Mojave 10.14.6 with integrated Intel...