Recent content by Junaid6305

What do you mean it didn't load in the right way? Having the same issue here.

Having the same issue here. Tried mapping the ports, and the BluetoolFixup kext but nothing worked.

ahh I see. Makes sense but why would it work if I boot to the OS via my install USB?

I did a fresh install and the screen just goes blank after this. I’m using this EFI https://www.tonymacx86.com/attachments/efi_usb_catalina_dell_5060_thn-zip.467343/

Right so I did a clean install then ran this Multibeast config. After I try boot from my SSD I just get a blank screen (doesn’t show bootloader) the system seems to be on as the caps lock lights still work but I’ve got no display output (I’m using VGA)

M No probs. I’m going to try a clean install then run multibeast to see it that works. As you said before it’s possibly my time machine backup with drivers etc from my old setup that could be affecting this.

Okay I managed to rebuild the kexts cache (https://www.tonymacx86.com/threads/rebuilding-kernel-cache-in-catalina.285643/) and I still have the same problem. Just reboots with the same error

I In EFI/CLOVER/kexts/Other I’ve got only Lilu.kext and VirtualSMC.kext. The command “sudo kextcache-i” doesn’t work, it just says command not found

I restored from my time machine backup then ran multibeast, but I also did run Beast Clean

I installed Catalina on my Dell Optiplex 5060 (Coffee Lake i7, 2X 8GB). The installation went fine and I restored from my old time machine backup (different hackintosh setup). I ran multibeast and just added Clover UEFI Bootloader Virtual SMC System def iMac 14,2 Graphics - Intel HD 630...

So I installed High Sierra on my computer and everything went pretty smoothly, I can boot into the drive via the boot loader on the install USB. After installation I installed clover via multibeast and when I try boot directly from the HDD I just get a flashing underscore. Asus P5G41T-M LX...

I did eventually manage to solve it, I messed around with so much I can’t remember everything exactly and it was a while ago as well. But I did create a new boot key with updated macOS and clover. I think that was the main part that fixed it. Maybe those also need to be updated for you, try it...

Okay I’m not sure what happened, I just restarted and went to settings and 4K 30Hz is back. Didn’t make any other changes (this is with my old EFI)

I managed to complete the 10.14.4 update by booting via my install USB. After updating I replaced my EFI folder with the one u attached and then installed the kexts as u suggested. Now when I try boot into my SSD the system won’t even go to the boot loader, the pc just restarts. With my old EFI...

It is from the Majove SSD. What should I add to SMBIOS and ACPI?