Recent content by ivanreel

Well. Chrome went very well. As soon as I booted Safari again the APP started crashing. So thinking it is a network WIFI fail ? Anyone have suggestions ?

Solved !!!! Yeah .. Wow this screams. I think my halting problem was my DDR3 memory DIMMS ! Pretty sure I had a bad stick of DDR3. I started with 16GB, 2x Corsair Vengeance LP and 2x Kingston KVR .. I then went back the 2 Corsairs. But then it only showed 1x4GB stick. So I switched DIMM slots...

I am so close! :) :( So after a successful installation process my Hackintosh will always hang after I first run pretty much any process. My build process and install goes very well. Using the latest Sierra Uni-beast. I keep my Multi-beast post installs to the basics. Meaning I don't worry...

So not sure if this will hope but I simply moved my boot USB key to on board USB port from case port and it stopped error'ing out on the boot.

When I swapped I got same error. Anybody else find solution? edit So not sure if this will hope but I simply moved my boot USB key to on board USB port from case port and it stopped error'ing out on the boot.

Giving it another shot this week. So close. All running great accept the both video onboard MB and the Geforce card installed.

Thanks Neil. I cant seem to find the older Buyer Guides that date back to SandyBridge and Iveybridge CPU era. Cheers. Ivan

Cant get my Geforce 450 working. However system boots fully and gives me a 1024x768 display option. No other options. I also cant get on board video running off MB. Assuming it is Intel Drivers. I have tried all the workarounds with Plist etc. I do have a CUDA board Quadro NVS 300. Any body...

Just can't get it to work. Used pList editor to enable inject Nvidia and also used text editor to make changes above. And new drivers for 10.12.3 NvidiaWeb downloaded. I had no remove Boot/Argument available on Plist file. Any ideas thx Ivan

addtional ... I note that the P8Z68-V Pro has on board video support up HDMI and DVI at 1920 x 1200 at 60Hz and RGB at 2048 x 1536 at 75Hz. However I don't think Clover supports it? Can not get it lit up on boot. Can you anyone comment on this? thx Ivan

So all went super smooth with USB Installer and Sierra 10.12.X I have seen loads of post about GTX450 and NvidaWeb drivers. Managed to install them but no luck in managing the card. I am newbie so when I try to go to do this ... little over my head. Think I could do it if I can get to the path...

All good System installed. I was not patient enough thx

Sorry Will do. Ivan

Hello all, Successfully got to Install screen. Installer finds target drive Sierra no problem. Duration states "About 15 minutes remaining" However, progress bar makes it 1/32 of the way across and logs line states ... PackageKit: Extracting...

FYI I also have this configuration with XEON CPU and Supermicro Motherboard. CPU Intel Xeon E3 1270 @ 3.40GHz 46 °C Sandy Bridge-WS 32nm Technology RAM 8.00GB Dual-Channel DDR3 @ 665MHz (9-9-9-24) Motherboard Supermicro X9SCL/X9SCM (CPU) 32 °C Graphics FP222W...