GTX 450 / i7 / Asustek MB

[ivanreel]

So all went super smooth with USB Installer and Sierra 10.12.X
I have seen loads of post about GTX450 and NvidaWeb drivers. Managed to install them but no luck in managing the card.
I am newbie so when I try to go to do this ... little over my head. Think I could do it if I can get to the path.

1. Mount EFI Partition - Are we talking about the USB Drive?
2. Open /Volumes/EFI/EFI/CLOVER/config.plist with text edit, Xcode, or Plist Editor Pro Can't find path
3. Edit as shown below:

Code (Text):
<key>SystemParameters</key>
<dict>
<key>InjectKexts</key>
<string>YES</string>
<key>InjectSystemID</key>
<true/>
<key>NvidiaWeb</key>
<true/>
</dict>
4. Remove Boot/Arguments/nvda_drv=1 if necessary
5. Save and reboot


Any ideas for help. So Close. Happy to get a new card that works with my install. This card is rather old now and I will be updating Intel Chip/RAM and SSD soon on this kit.

Kind Regards
Ivan

 

[ivanreel]

addtional ...

I note that the P8Z68-V Pro has on board video support up HDMI and DVI at 1920 x 1200 at 60Hz and RGB at 2048 x 1536 at 75Hz. However I don't think Clover supports it? Can not get it lit up on boot. Can you anyone comment on this?

thx
Ivan