CaseySJ
Moderator
- Joined
- Nov 11, 2018
- Messages
- 22,224
- Motherboard
- Asus ProArt Z690-Creator
- CPU
- i7-12700K
- Graphics
- RX 6800 XT
- Mac
- Classic Mac
- Mobile Phone
Hello @nifranza,Hello @CaseySJ, hope you're doing well. Just have a quick question regarding a small issue with the last 2 updates of OpenCore.
After updating from 0.6.6 to 0.6.7, and now to 0.6.8, I get a forbidden symbol when booting to macOS (10.15.7). When it happens, I go pass through it by reseting the NVRAM in the picker, but after some time it comes back, and I need to reset the NVRAM again for it to go away and boot into macOS. I don't know what's causing it. I did not tried adding -v to try to see what the error is yet.
Do you have any clue about this, or is it a known issue?
Thanks in advance.
Couple of suggestions to try:
- Replace the coin cell battery on motherboard.
- Perform CMOS Reset (which then requires BIOS parameters to be configured once again, starting with F7 [Load Optimized Defaults]).
[SUCCESS] Gigabyte Designare Z390 (Thunderbolt 3) + i7-9700K + AMD RX 580
Hello Casey Why do you insist on 2.33.1.0 while they say 2.33.0.0 works fine with OC 0.6.8 on this page : https://mackie100projects.altervista.org/occ-changelog-version-2-33-0-0/ Did I miss something? I use OC 0.6.3 for mounths (thanks to you :)) and I see I arrived just in time for doing an...
www.tonymacx86.com