Sniki
Moderator
- Joined
- Jan 5, 2016
- Messages
- 2,313
- Motherboard
- HP Elite 8300 SFF
- CPU
- i7-3770
- Graphics
- Intel HD 3000 | GTX 1650 LP
- Mac
- Mobile Phone
Your setup lacks many corrections:Hello.
I have the following case:
1. I have a newly installed Mojave 10.14.4 on Asus Z390A-Prime, i5-8400 and RX560.
2. I set PluginType=true inside the config.plist.
3. Check into IOReg, x86PlatformPlugin is loaded under PRO0@0 (it is not CPU0@0 as the guide stated).
4. I ran Hackintool to patch my framebuffer, creating a Headless system using 18,3 system definition.
5. After resetting the system, x86PlatformPlugin no longer loaded (search cannot find any x86PlatformPlugin).
6. Disable the PluginType=true and enable again, but no difference (x86PlatformPlugin still not loaded).
I didn't have a chance yet to run the AppleIntelInfo before and after, but I do the following test using Cinebench and Intel Power Gadget with the following result:
1. System idle then run Cinebench.
View attachment 413084
2. Finish Cinebench then system idle
View attachment 413085
3. System idle then running Cinebench again
View attachment 413086
I attach Problem Reporting files, even though without the requested problem reporting files, hopefully somebody is willing to look at my case and give advise about what is going on and how to enable the CPU PM?
Thank you.
config.plist /ACPI/DSDT/Patches:
change EC0 to EC
change HDAS to HDEF
change SAT0 to SATA
change GFX0 to IGPU
These are mandatory to have a properly functioning setup (which are missing and needed for your setup).
"Especially" GFX0 to IGPU is important for Power Management to work.
If for any reasons you have kernel panic or get stuck on loading bar on Apple Logo, disable the EC0 to EC patch on clover boot menu.
Make these changes and see if Power management works.