If I were you, I would rather create a new USB Installer using Unibeast method and try again. I would also disconnect all unneeded SATA and USB devices and just have the Installer USB FD and target HDD attached to the system while this installation is going on.
You have to use fakecpuid with the Broadwell-E chips
What boot flags are you using? In Clover>Options>Boot Args: add npci=0x2000 to other flags to overcome current boot arrest at [PCI Configuration begin] In some case it can be npci=0x3000 so try in sequence if the earlier one fails.ok I have some updates.
I followed this guide exactly https://www.tonymacx86.com/threads/giacomoleopardos-workstation-triplet.199643/
but I'm using Sierra instead of El Capitan. I managed to pass where I'm stuck. I'm reaching this now:
[PCI configuration begin]
com.apple.appleFSCompressionTypeZllb mod start
then the computer restarts automatically.
Any idea could it be? any help would be much appreciated.
Thank you
I'd like to direct you to a mini-guide I made with my x99 chipset board: here
Try the BIOS settings and EFI's I used if you haven't already tried them.
Usually the +++ error is either a RAM issue or an unknown CPU. Go to Clover's options on preboot and enable the KernelCPU fix.
If you have a PCI panis you may be missing the npci=0x03000 bootflag.
Hope this helps.
What boot flags are you using? In Clover>Options>Boot Args: add npci=0x2000 to other flags to overcome current boot arrest at [PCI Configuration begin] In some case it can be npci=0x3000 so try in sequence if the earlier one fails.
Good luck
ghosts in my systems