- Joined
- Jan 10, 2014
- Messages
- 11
- Mac
- Classic Mac
- Mobile Phone
So I built the hackintosh and turned it on for the first time, went to the BIOS screen, changed some settings, saved and quit, and now every time I turn the computer on it's not sending a signal to the monitor...What do I do? I followed the settings of Mike7060 for the GA-Z87m-D3H, as he has the same MB as I do. I also have anIntel Core i7-4770 and no graphics card...what went wrong
These were the Settings I used:
2. Set to Optimized Defaults.
3. Set X.M.P. Memory Profile to Profile1
4. Set XHCI Mode to Auto not Smart Auto
5. Set XHCI Hand-off to Enabled
6. Set EHCI Hand-off to Enabled
7. Set VT-d to Disabled
8. Set Intel Processor Graphics to Disabled
9. Set SATA Mode Selection to AHCI
10. Set PCIe Slot Configuration Gen3
11. Save and exit.
These were the Settings I used:
2. Set to Optimized Defaults.
3. Set X.M.P. Memory Profile to Profile1
4. Set XHCI Mode to Auto not Smart Auto
5. Set XHCI Hand-off to Enabled
6. Set EHCI Hand-off to Enabled
7. Set VT-d to Disabled
8. Set Intel Processor Graphics to Disabled
9. Set SATA Mode Selection to AHCI
10. Set PCIe Slot Configuration Gen3
11. Save and exit.