RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,015
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
As you all know (from reading post #1), it is not wise to use the "Silent Fan Patch" with Clover, especially in a multi-boot scenario.
Today, I've ported Fanreset.dylib (used in Chameleon) as a Clover EFI driver (64-bit only). It is attached for those who would like to help test it. Place in EFI/CLOVER/drivers64UEFI.
Note: So far, tested only on my 4530s.
Update: Tested on my 4540s. It did not crash (even with CSM disabled), which was my concern. And it "thinks" it is successful, so it is probably working, but the furnace stopped working in the middle of the night here and it is very cold outside (-24C) and therefore relatively cold inside until the furnace gets caught up again. I will test more when the ambient temperature has risen a bit...
Update #2: Tested to my satisfaction. See: http://www.tonymacx86.com/hp-proboo...avericks-clover-bootloader-31.html#post720110
Today, I've ported Fanreset.dylib (used in Chameleon) as a Clover EFI driver (64-bit only). It is attached for those who would like to help test it. Place in EFI/CLOVER/drivers64UEFI.
Note: So far, tested only on my 4530s.
Update: Tested on my 4540s. It did not crash (even with CSM disabled), which was my concern. And it "thinks" it is successful, so it is probably working, but the furnace stopped working in the middle of the night here and it is very cold outside (-24C) and therefore relatively cold inside until the furnace gets caught up again. I will test more when the ambient temperature has risen a bit...
Update #2: Tested to my satisfaction. See: http://www.tonymacx86.com/hp-proboo...avericks-clover-bootloader-31.html#post720110