[GUIDE] macOS 13 Ventura Public Beta with OpenCore on Z390 Aorus Elite

[UtterDisbelief]

Hi z490 vision g, 10700, igpu are ok you efi for me ? thanks for your help

You do not have the same hardware as the OP. Please, start your own thread in the Ventura Support forum if you need help with a specific problem.

 

[miliuco]

Hi z490 vision g, 10700, igpu are ok you efi for me ? thanks for your help

No, I don't think so, look for Z490 mobos and Comet Lake CPUs.

 

[Asket7]

EFI

miliuco, i try to boot from your bootloader immediately stops.
Please forgive me, I'm trying to master opencore.
What is my mistake ?

 

[miliuco]

@Asket7
Strange. This EFI is capable to boot your PC even without the wifi or any other different component.
What SMBIOS do you have? iMac19,1? Did you select config-13-imac-amd.plist and rename it to config.plist?
Remove agdpmod=pikera boot arg, not needed with RX 580.
Do ResetNVRAM once booting with a new EFI.

 

[Asket7]

@Asket7
Strange. This EFI is capable to boot your PC even without the wifi or any other different component.
What SMBIOS do you have? iMac19,1? Did you select config-13-imac-amd.plist and rename it to config.plist?
Remove agdpmod=pikera boot arg, not needed with RX 580.
Do ResetNVRAM once booting with a new EFI.

I chose config-13- imacpro1,1 (imacpro1,1 is running on clover). Yes, nvram was reset.

 

[miliuco]

@Asket7
Ok, but do you rename the file to config.plist? I guess you do.
Agdpmod=pikera removed?

 

[Asket7]

@Asket7
Ok, but do you rename the file to config.plist? I guess you do.
Agdpmod=pikera removed?

Renamed. Removed pickers. Failed to load.
After that, my configuration on Clover did not want to load ))), I updated the bios.
But it still didn 't work out )

 

[miliuco]

@Asket7
Are you trying to install Ventura developer beta 5 or public beta 2?

 

[Asket7]

@Asket7
Are you trying to install Ventura developer beta 5 or public beta 2?

Ventura Beta 2

 

[miliuco]

Ventura Beta 2

Really I don't know what the problem is. I can boot public beta 2 with this EFI. Your motherboard is not so different.
To be able to boot back with the previous working Clover, delete all in EFI partition and copy there the Clover EFI. If you can reach the Clover menu, at first boot press F11.