- Joined
- Mar 29, 2014
- Messages
- 18
- Motherboard
- NUC
- CPU
- i7
- Graphics
- HD 6100
- Mac
- Classic Mac
- Mobile Phone
Don't forget to use 'make install_nuc8bc' to get the correct AMLs in ACPI/patched.
You cannot use the final config.plist without correct SSDTs in ACPI/patched.
Also, make sure kexts are installed via download.sh/install_downloads.sh.
Check too that BIOS settings are correct. Very important to have legacy boot enabled.
Fix the first problem, then test again.
If you have an issue, you must attach PR files.
I started fresh, re-partitioned the disk, mounted and deleted everything in the EFI. Reset bios to defaults and followed the doc's and applied the setting. I encountered a couple of problems after the install completed I was unable to boot to macos as it was in a reboot loop. I had to boot single mode to be able to finish configuring the os. I ran through the post install but the install_downloads.sh failed. I had to run install_downads.sh with sudo for it to succeed. mount_efi.sh also failed and had to manually mount to finish the install. when rebooting clover showed no disks to boot. I booted off the install USB, and had to manually add ApfsDriverLoader, HFSPlus and EmuVariableUefi. Yes, I moved the config_nuc8_bc.plist to config.plist. Now I can see the boot disk and when I try and boot I get a black screen and it never boots.
Attached are the debug files any help would be appreciated.