- Joined
- Apr 17, 2012
- Messages
- 84
- Motherboard
- HP Probook 640 G2
- CPU
- i5-6300U 2.5GHz
- Graphics
- HD520 1920x1080
- Mac
- Classic Mac
- Mobile Phone
[Guide] Gigabyte BRIX-s using Clover UEFI (GB-BXi5H-4200)
You're probably right. I'm at a total loss trying to make sense of the information in IORegistryExplorer. I have been since this El Capitan USB issue started.
Initially, I figured the USB3 were using ports 0F, 10, 13 & 14 based on what I saw in IORegistryExplorer. Perhaps you'll discover the correct information. You will see everything but the last test struck out since they were disconnected to test the next port. I used a Mouse to test the USB2 and a hard drive to test the USB3. This test was with the SSDT-USB.aml removed and the patch below back into the config.plist:
LasVegas
Please post ioreg. The port address assignments don't make sense for that XHC device-id.
They also don't match your IOACPIPlane. I suspect USB3 devices will not work at USB3 speeds with that configuration.
My original configuration is correct, I think...
You're probably right. I'm at a total loss trying to make sense of the information in IORegistryExplorer. I have been since this El Capitan USB issue started.
Initially, I figured the USB3 were using ports 0F, 10, 13 & 14 based on what I saw in IORegistryExplorer. Perhaps you'll discover the correct information. You will see everything but the last test struck out since they were disconnected to test the next port. I used a Mouse to test the USB2 and a hard drive to test the USB3. This test was with the SSDT-USB.aml removed and the patch below back into the config.plist:
Code:
<dict>
<key>Comment</key>
<string>change 15 port limit to 20 in AppleUSBXHCIPCI</string>
<key>Find</key>
<data>g72M/v//EA==</data>
<key>Name</key>
<string>AppleUSBXHCIPCI</string>
<key>Replace</key>
<data>g72M/v//Gw==</data>
</dict>
LasVegas