- Joined
- May 11, 2011
- Messages
- 103
- Motherboard
- ASUS PRIME Z490-A
- CPU
- i9-10850K
- Graphics
- RX 580
- Mac
- Mobile Phone
Thanks for the reply , should i do anything with CON 2 to set ti to dummy or just leave it? My IGPU is UHD Graphics 630 not 620.You have con0 and con1 set as HDMI connectors. This is why these DeviceProperties for the UHD 620 IGPU work for you. While you are using a HDMI connection.
One of these two connectors is set wrong, as they should reflect the physical state of the connector, i.e. one should be set as DisplayPort.
Con2 isn’t set with a connector type. Probably should be set as a ‘Dummy’ connector.
I will set one of the ports to DP and see if they both work at a later date, i can try CON 0 as HDMI CON1 as DP and if it doesnt work swap them around.
I got lost trying to work out my bus id ect, if its working should i be worried? I don't get why CON0 and CON2 have a bus ID but CON 1 does not.