- Joined
- Jan 31, 2014
- Messages
- 4
- Motherboard
- GIGABYTE GA-Z87M-D3H DDR3-RAM KIT 16GB, 1600MHz, CL10
- CPU
- INTEL Core i7 - 4771
- Graphics
- Zotac GTX660 Ti 2048MB 192Bit DDR5
- Mac
- Classic Mac
- Mobile Phone
Hi guys,
I've got myself a GIGABYTE GA-Z87M-D3H and INTEL Core i7 - 4771 and have successfully installed Mavericks thanks to your guide(s)! Thus kudos to you
However, I have run MultiBeast and amongst others I've selected Drivers > Misc > USB 3.0 - Universal. Afterwards I have installed this configuration successfully.
But data transfer to my USB3.0 stick using the USB3.0 port does not achieve USB3.0 speeds.
In average I've got 10MB/s while writing and around 70MB/s while reading. That's not so much USB3.0 as I would expect
Thus, what do I need to configure how in order to achieve full write and read speeds via USB3?
Thanks in advance!
I've got myself a GIGABYTE GA-Z87M-D3H and INTEL Core i7 - 4771 and have successfully installed Mavericks thanks to your guide(s)! Thus kudos to you
However, I have run MultiBeast and amongst others I've selected Drivers > Misc > USB 3.0 - Universal. Afterwards I have installed this configuration successfully.
But data transfer to my USB3.0 stick using the USB3.0 port does not achieve USB3.0 speeds.
In average I've got 10MB/s while writing and around 70MB/s while reading. That's not so much USB3.0 as I would expect
Thus, what do I need to configure how in order to achieve full write and read speeds via USB3?
Thanks in advance!