- Joined
- Aug 5, 2015
- Messages
- 52
- Motherboard
- Gigabyte GA-Z97X-UD7 TH
- CPU
- i7-4790K
- Graphics
- RX 580
I've built before and I'm (pretty) sure I'm not going crazy, but my ATX mobo doesn't fit my ATX Mid-Tower case.
The I/O is pretty bulky and the shield is already pre-installed on this Asus board. I suspect I can't get a tight fit because of this. I can't even get the center standing peg in, but was able to get it where a couple of the the lower pegs could have been screwed in (but not the top ones)
Help!
The I/O is pretty bulky and the shield is already pre-installed on this Asus board. I suspect I can't get a tight fit because of this. I can't even get the center standing peg in, but was able to get it where a couple of the the lower pegs could have been screwed in (but not the top ones)
Help!