** OpenCore 0.8.0 Released **
To upgrade to OpenCore 0.8.0 please follow the HackinDROM instructions located here:
It would be good to check that all cables and PCIe cards are securely connected. Power cables should be checked on both sides (on PSU and on motherboard/GPU -- don't forget the GPU). Looking at my previous post, I guess I need to get another graphics card. Does it need to be the RX580? Would...
www.tonymacx86.com
However, do
not use OpenCore Configurator 2.59.0.0 because it is not compatible with the release version of OpenCore 0.8.0. Instead, use OpenCore Configuration
2.60.0.0. After performing the upgrade with HackinDROM, no further changes or edits are needed.
Always keep a backup copy of previous OpenCore EFI folder in the EFI partition of a USB flash disk (for emergency boot).
Monterey Users:
The existing
SmallTree-Intel-211-82576.kext
for the Intel i211-V Ethernet port does not work in Monterey, but thanks to
@gagaraz who found a newer version, the port works once again.
Procedure (see screenshot below):
- Set MaxKernel to 20.99.99 in config.plist --> Kernel for SmallTree-Intel-211-82576.kext
- Add an entry in the same Kernel section for SmallTree-Intel-211-8259x.kext
- Set MinKernel to 21.0.0 for this new kext
- Also copy the file (attached) to
EFI/OC/Kexts
folder in the EFI partition
Once you make this change, you will
not need to make it again when next version of OpenCore is released.
View attachment 546315