This is what I got:
2018-10-19 14:38:08 +0800 Failure Darkwake Exit Failure during wake due to 0xCD49FC3000000032:
2018-10-19 18:41:37 +0800 Failure Drivers Failure panic during wake due to...
I'm having sleep = shutdown problem too.
After the 'shutdown', press any key will start the computer but it didn't go to the login screen, instead it trigger a complete Restart. When it reach to boot the macOS it showing the kernel panic screen (below). Restart again will boot normal...
Clean installed Mojave by following this guide. Used a few days to test the setting, reinstall or reboot many times, so patient is the key. Now everything seems to work except the famous sleep/wake problem. There are some highlights:
Use MultiBeast to install AppleALC, FakeSMC, WhateverGreen...
For my setting GA-H170N-WIFI / i7-6700 / HD 530:
Not work (Stucked at about 70% of the Apple loading screen):
Drag Lilu.kext + IntelGraphicsFixup.kext into /Library/Extensions.
Note:
1. Tried KextBeast.
2. Tried AppleStore update & Combo update.
3. Tried update Clover and MultiBeast with...
For those upgrade from El Captain the problem of growing numbers of boot entries may arise again. In my case, I got over 40 entries after 1 week of upgrading to Sierra!
https://www.tonymacx86.com/threads/guide-remove-extra-clover-bios-boot-entries-prevent-further-problems.175274/
Basically, I...
The audio worked finally. Tried 3 days just install and restore...I'm not sure is there anything I did help but the last step I made was MultiBeast > Driver > choose 'ALC1150', 'Optional HD 3000...HDMI Audio' & '100 Series Audio' > Build > Install, and then restart.
I upgraded from El Captain to Sierra, everything is ok except the audio. I even don't understand the guideline! Could anyone help me with this particular board using ALC1150?
At 3200 x 1800, it shows 30Hz and has been grey out, which means you cannot change it. With lower resolution I can choose 24Hz, 25Hz, 30Hz & 30Hz. The lower two frequency give me more flashing & noise, and I don't know why there is two duplicated 30Hz.
I'm using one HDMI cable one monitor. Holding the option key while you hit the Scaled button in the display preference will give you more resolution options.
The integrated graphics can drive my Dell P2415Q 3840 x 2160 30Hz. Everything is sharp but tiny so I have to lower it to 3200 x 1800 (low resolution) to make graphics bigger. Low resolution means blurry graphics but at this lower resolution using 24" monitor the blur is still sharp to me.
Tried...
I'm using the same SSD (2.5" one). Can you open Disk Utility from the menu bar at the top? You should see the SSD but you need to Erase (format) it for the installation of OS.
I need to give my x10000 thanks to Ammulder with the detailed guideline. My building parts are nearly the same (using internal GPU) and it works fine. The difficult part is fine tuning those sleep/wake and flashing screen problems when using internal GPU. It's rather stable now but I'm still not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.