Contribute
Register

Black screen after boot on Mojave

Status
Not open for further replies.
okay, a new issue.
My monitor seems to lose signal during the boot and when I turn it back on the screen is just black?
 
In this case revert back to the previous config.plist, but in the Devices section of Clover Configurator, set IntelGFX to 12345678. Then save the file (EFI partition of USB install disk) and try booting again.
 
Yes! back to Language selection screen! :headbang: Cheeehooooo!
and back to the mouse not working and its just chilling in the corner of the screen :banghead:
 
Yes! back to Language selection screen! :headbang: Cheeehooooo!
and back to the mouse not working and its just chilling in the corner of the screen :banghead:
In your config.plist, in the Devices section, under the USB section along the top, check on:
  • Inject
  • Fix Ownership
Then save the file to EFI partition of USB install disk and see if the mouse can move...
 
Done, the mouse still doesn't move.
 
Done, the mouse still doesn't move.

  • Reboot> to Clover Boot Manager Screen>Options>PCI Devices screen and take its Photo
Upload that photo OR
  • if it is easier to upload your USB Installer's CLOVER folder as zipped, then CLOVER.zip
  • Where in the back Panel USB ports you have inserted Mouse, Keyboard and USB Installer Disk?
  • Or are they connected to Front Bezel USB Ports?
 

Attachments

  • Back panel USB Ports.png
    Back panel USB Ports.png
    201 KB · Views: 67
  • Reboot> to Clover Boot Manager Screen>Options>PCI Devices screen and take its Photo
Upload that photo OR
  • if it is easier to upload your USB Installer's CLOVER folder as zipped, then CLOVER.zip
  • Where in the back Panel USB ports you have inserted Mouse, Keyboard and USB Installer Disk?
  • Or are they connected to Front Bezel USB Ports?
 

Attachments

  • Back panel USB Ports.png
    Back panel USB Ports.png
    216.7 KB · Views: 68
  • CLOVER.zip
    3.8 MB · Views: 61
Does the mouse work if you move it to the red or blue USB port?
 
Does the mouse work if you move it to the red or blue USB port?
No, I've tried all ports; even the two 3.0 USB port that comes with the case it still doesn't work.
 
I have not made any changes to the boot drive but now it freezes here.
 

Attachments

  • 536CAF28-4966-443E-BE8E-588E966D7A2C.jpeg
    536CAF28-4966-443E-BE8E-588E966D7A2C.jpeg
    4.8 MB · Views: 57
Status
Not open for further replies.
Back
Top