- Joined
- Apr 26, 2014
- Messages
- 16
- Motherboard
- b350
- CPU
- i7 3632qm
- Graphics
- hd4000
- Mac
- Classic Mac
- Mobile Phone
not workFollow the guide. It should work the same
not workFollow the guide. It should work the same
Whats not working, on boot?, Graphics?not work
hd5500 graphicsWhats not working, on boot?, Graphics?
Are you using the Post-Install config.plist and kexts?hd5500 graphics
yesAre you using the Post-Install config.plist and kexts?
Check if whatevergreen.kext is loaded via About This Mac > System Report > Extentions.
iASL Warning: There were 27 external control methods found during dissasembly, but only 9 were resolved (18 unresolved). Additional ACPI tables may be required to properly dissasemble the code.
Line 4030, Code 6126: syntax error, unexpected PARSEOP_ZERO
Line 4097, Code 6126: syntax error, unexpected PARSEOP_ZERO
use the parseop fixes, more info can be found here:I'm trying to replicate the instructions in this guide, but I've run into an issue. When I try to decompile my DSDT that I extracted with Clover, I get this:
Code:iASL Warning: There were 27 external control methods found during dissasembly, but only 9 were resolved (18 unresolved). Additional ACPI tables may be required to properly dissasemble the code.
And when I go to compile my DSDT in MaciASL, I get this:
Code:Line 4030, Code 6126: syntax error, unexpected PARSEOP_ZERO Line 4097, Code 6126: syntax error, unexpected PARSEOP_ZERO
Am I going about this wrong? I do have the i5 version of the laptop, but it shouldn't make a difference if I am decompiling my own DSDT, should it?
Were you decompiling with refs.txt?I'm trying to replicate the instructions in this guide, but I've run into an issue. When I try to decompile my DSDT that I extracted with Clover, I get this:
Code:iASL Warning: There were 27 external control methods found during dissasembly, but only 9 were resolved (18 unresolved). Additional ACPI tables may be required to properly dissasemble the code.
And when I go to compile my DSDT in MaciASL, I get this:
Code:Line 4030, Code 6126: syntax error, unexpected PARSEOP_ZERO Line 4097, Code 6126: syntax error, unexpected PARSEOP_ZERO
Am I going about this wrong? I do have the i5 version of the laptop, but it shouldn't make a difference if I am decompiling my own DSDT, should it?